Cookbots

Cookbots can be fitted with home tools, however, you will likely need to source a press to get the alloy insert into the arm. You may get by with a vice, but it is not recomended.  Freezing the bush prior to fitting and a little grease may help it slide into place. This guide is for referance only and should only be attempted if you have the skills needed to complete the instalation safely. 

1. Either 1, undo the ball joint taper nut or 2 undo the 3 lower nuts.  The red line indicates where you may need to cut if you cannot free the top nut.

2. Undo the front bolt 1

1. Undo the rearmost nut and bolt 1 and 2.

4. remove the old bush by either pressing, burning or drilling it out. 

5. Press in the new bush using a 32mm socket having frooze and greased it.

6. Refitting is the reverse.